Cisco 600-212 Exam Topics:
| Section | Weight | Objectives |
|---|---|---|
| Lawful Intercept | 5% | 1 Describe lawful intercept architecture and events 2 Configure lawful interception 3 Describe lawful intercept trigger element |
| SGW (4G LTE) | 10% | 1 Network functions LTE-SGW a) Identify key functions of the SGW and basic understanding of architecture and interfaces b) Describe SGW attach procedures and call flows c) Configure S1-U interface with corresponding services and system parameters d) Configure S5/S8 using PMIP/GTP interface with corresponding services and system parameters e) Configure S11 interface with corresponding services and system parameters 2 Feature functionality and extended application a) Describe multi-PDN support for SGW b) Describe downlink delay notification for SGW c) Describe idle mode signaling reduction support for SGW d) Configure and implement IPV6 support for SGW 3 Internetworking between LTE and other technologies a) Describe interaction with CDMA/eHRPD internetworking b) Describe interaction with GSM/UMTS internetworking c) Configure S4 interface with corresponding services and system parameters d) Configure S12 interface with corresponding services and system parameters e) Configure S103 interface with corresponding services and system parameters 4 Charging a) Configure Gx interface with corresponding services and system parameters 5 QoS a) Describe QoS bearer management and marking for SGW b) Configuring DSCP marking for SGW |
| MME (4G LTE) | 16% | 1 Network functions LTE –MME a) Identify key functions of the MME and basic understanding of architecture and interfaces b) Describe MME states of MM and CM management c) Describe protocol stacks and procedures d) Describe mobility management signaling and call flows e) Describe session management signaling and call flows f) Describe location management signaling and call flows g0 Describe SGS procedures and signaling call flows h) Describe intra-MME handovers procedure i) Describe intra-RAT handovers procedure j) Describe inter-MME handover procedures 2 QOS architecture a) Describe the overall QOS functionality in LTE for single and multi pdn b) Describe the QOS mapping from UMTS to LTE 3 Configurations a) Configure S1 interface with corresponding services and system parameters b) Configure S6a interface with corresponding services and system parameters c) Configure S11 interface with corresponding services and system parameters d) Configure S13 interface with corresponding services and system parameters e) Identify and implement gateway selection mechanisms f) Identify and implement MME operator policy and feature sets g) Troubleshoot configurations 4 Network sharing a) Describe MOCN architecture b) Describe GWCN architecture 5 Security a) Describe LTE security principles for MME network node b) Explain security functions for mobility management procedures 6 Idle mode signaling reduction a) Identify IDLE mode signaling reduction in an LTE network b) Describe IDLE mode signaling establishment c) Describe IDLE mode signaling reduction deactivation 7 CSFB a) Describe CSFB architecture in LTE network b) Describe CSFB call flow and signaling 8 IPv6 support a) Configure IPV6 and dual stack EPS bearer scenarios b) Configure and implement transport plane IPV6 support for MME |
| Management Protocols | 11% | 1 TACACS a) Describe admin authentication and command authorization methods b) Configure Local administration levels c) Configure external authentication TACACS servers 2 Performance counters/statistics a) Describe the various performance counters b) Describe the collection and processing of performance counters c) Describe the common KPIs for various MPC nodes d) Configure counters and KPIs 3 Fault management a) Describe SNMP protocols, alarms, notification and MIBs b) Configure SNMP traps, filters and thresholds 4 syslog/events Log a) Describe system log formats and filters b) Configure syslog servers and event logs 5 Security a) Describe user access control 6 NTP a) Describe system timing b) Configure NTP servers, system clock, time zone and timestamps |
| Charging | 13% | 1 Offline charging service a) Describe offline charging architecture b) Explain the GTPP protocol header and messages c) Explain charging data record transport through GTP' d) Compare and contrast GTPP transfer scenarios e) Describe and differentiate mobility records generated by MPC nodes f) Identify and list conditions for record closure and generation g) Explain Rf offline charging scenarios h) Identify and list offline charging error cases i) Configure for offline billing j) Troubleshoot for offline billing |
| Voice Over LTE | 20% | 1 VoLTE application messages/protocols a) Describe VoLTE specific diameter interface b) Describe XCAP, LDAP, SPML c) Describe CAMEL, CAP, INAP, SOAP, MSML 2 Voice over LTE architecture a) Describe voice evolution in mobile network b) Identify VoLTE system architecture and functions of network elements 3 Network elements in voice over LTE a) Describe CSCF b) Describe ENUM c) Describe MNP — mobile number portability/database d) Describe telephony application server e) Describe DRA/DEA f) Describe HSS g) Describe PCRF h) Describe ATCF,ATGW i) Describe MRF j) Describe understand OSS and BSS 4 QoS a) Describe QoS in EPS b) Describe end-to-end QoS in VoLTE 5 Interfaces and signaling messages a) Configure Gx interface and signaling b) Design Rx interface and signaling c) Implement Cx interface and signaling d) Describe ISC interface and signaling e) Describe Ut interface 6 End-to-end call flow a) Describe IMS client attach to EPC b) Describe P-CSCF discovery c) Describe IMS registration, re-registration and de-registration d) Describe mobile-originated VoLTE call e) Describe mobile-terminated VoLTE call f) Describe emergency VoLTE call 7 Supplementary services a) Describe IR.92 supplementary service overview b) Describe IR.94 supplementary service overview c) Describe Important services call flows 8 VoLTE Interworking a) Describe PSTN interworking b) Describe IMS/SIP interworking c) Describe e-SRVCC |
| LTE | 5% | 1 Describe and differentiate LTE / SAE architecture 2 Explain attach procedure and call flow |
| Other Interfaces | 5% | 1 AAA/diameter related interfaces a) Describe SWx interface b) Describe S9 interface c) Describe Sp interface 2 HRPD related interfaces a) Describe S101 b) Describe S103 |
| PGW (4G LTE/EHRPD) | 15% | 1 Architecture overview a) Identify key functions of the PGW and basic understanding of architecture and interfaces 2 Implement S5/S8 and Gn/Gp interface a) Describe GTP protocol b) Describe mobility management/session management call flows c) Describe QoS in EPC d) Configure S5/S8 interface with corresponding services and system parameters e) Troubleshoot S5/S8 and Gn/Gp 3 APN a) Describe the various IP address allocation mechanisms b) Describe the concept of virtual APNs c) Configure APNs and virtual APNs with corresponding service and system parameters d) Configure IP source address validation and access control list e) Troubleshoot APN 4 Implement Gx interface a) Describe the important diameter AVPs needed for Gx b) Describe basic Gx call flows c) Configure Gx interface with corresponding services and system parameters d) Troubleshoot Gx interface e) Describe the common policy use cases f) Configure failure handling modes g) Configure usage monitoring over Gx 5 Implement Gy interface a) Describe the important diameter AVPs needed for Gy b) Describe the basic Gy call flows c) Configure Gy interface with corresponding services and system parameters d) Troubleshoot Gy interface e) Configure failure handling modes f) Describe OCS selection based on static configuration g) Describe RADIUS attributes and PCRF out-of-quota redirection handling 6 Implement AAA Interface a) Describe the basic AAA authentication and accounting call flows b) Describe the important RADIUS attributes for authentication and accounting c) Configure RADIUS interface with corresponding services and system parameters d) Troubleshoot RADIUS interface 7 Implement S6b interface a) Describe the important diameter AVPs needed for S6b b) Describe the basic S6b call flows c) Configure S6b interface with corresponding services and system parameters d) Troubleshoot S6b interface 8 Interworking with non-3GPP access networks a) Configure S2a interface with corresponding services and system parameters b) Configure S2b interface with corresponding services and system parameters c) Configure S2c interface with corresponding services and system parameters d) Configure LMA functionality on a PGW e) Configure non-3GPP IRAT handovers f) Troubleshoot S2b and S2c interfaces 9 SGi Interface a) Configure and implement various IP transport types b) Configure and implement static and dynamic routing protocols |
In the end purchasing 600-212 test questions and dumps will be the best choice for your exam. We assure you 100% pass 600-212 exam with our exam cram pdf file. No help Full Refund.
The 600-212 test questions and dumps have three versions:
1. The exam cram pdf file is used to reading directly and printing out for 600-212 practice.
2. The test exam soft version is used to download on computer to test online and 600-212 exam simulation.
3. The test exam online version is used to download on all electronics including soft version's functions. It is interactive and interesting for 600-212 studying.
So if you choose to buy 600-212 test questions and dumps it is more efficient for you to pass the test exam. You just master and recite the test questions and dumps. It saves a lot of time and money. You will feel casual while 600-212 test online by our soft.
So far we are the best 600-212 test questions and dumps provider. We can guarantee you pass exam. If you fail the 600-212 exam and we will full refund to you.
Before purchasing I advise you to download our free 600-212 exam cram pdf. It is free for your reference. You enter your email address and download 600-212 dumps, very easy. Also please rest assured that your information will be kept in secret and safe. We won't send you advertisement without your permission.
After purchasing you can download the complete 600-212 test questions and dumps soon even in official holidays. We are 7*24 online service. Whenever you send emails to us we will reply you in two hours.
After passing test exam if you still want to get the latest version about 600-212 test questions and dumps please provide your email address to us, we will send you once updated. We have one-year service warranty. If you do not provide us email address we will think you do not want to receive these emails and won't send you junk emails.
After passing test exam if you want to purchase other test exam questions and 600-212 dumps we will give you discount. Or if you purchase for your company and want to build long-term relationship with us we will give you discount too. Please email us your thoughts. You will have priority to get our holiday sales coupe as one of our old customers.
Some people wonder how they can improve themselves and get promotion; they feel their career is into a bottleneck. Yes it is time to study, pass exam and get the vital certification with 600-212 test questions and dumps. Once there is a good opportunity you will have vital advantages and stand out. Why are 600-212 test questions and dumps important? The reason is below:
1. The 600-212 test exam is very difficult and the failure rate is quite high according to official statistics.
2. The 600-212 test cost is high; if you fail you should try and pay twice or more.
3. Since you are a busy-working man you may have little time on systematic studying and preparation before the real 600-212 test exam. You will feel nervous and stressful every day before you pass the 600-212 test exam.
4. You will feel aimless while studying without 600-212 exam cram sheet. You will waste more time and your efficiency will be low.
Cisco 600-212 Exam Certification Details:
| Recommended Training | Implementing Cisco Service Provider Mobility LTE Networks – (SPLTE) |
| Passing Score | Variable (750-850 / 1000 Approx.) |
| Exam Name | Implementing Cisco Service Provider Mobility LTE Networks |
| Exam Code | 600-212 SPLTE |
| Exam Price | $300 USD |
| Number of Questions | 65-75 |
| Sample Questions | Cisco 600-212 Sample Questions |
| Exam Registration | PEARSON VUE |
| Duration | 90 minutes |
