IBM C2080-470 : IBM Unica Campaign V8.5

Many flowcharts are finishing with errors but the user cannot see any activity leading up to the error in the flowchart log as logging is set too low. What can be recommended to capture more logging in all future flowchart runs?

• A. Change the logging levels in the campaign_log4j.properties file and restart the web application server.
• B. Change the levels in the following configuration settings: Settings > Configuration --> Unica > Campaign > partitions > partition[n] > server >logging.
• C. Have the user change the logging levels in every flowchart they run: the changes will persist.
• D. Use the unica_svradm "loglevel HIGH" command.

The Unica Platform has been integrated with an Active Directory solution. Due to changes in Active Directory, a specialist needs to make sure that ALL groups and users from the Active Directory solution are synchronized with the Unica Platform. This can be accomplished by:

• A. using the automatic synchronization method.
• B. using an Extraction Transformation Loading (ETL) routine between Active Directory and Unica Platform.
• C. using the manual synchronization function.
• D. using the Unica Marketing Platform config tool utility.

In a Unica Campaign Flowchart, a customer database table (see below) is mapped in a Select process box. There is a requirement to segment and organize customers based on their income, which would typically have the values "HIGH" for customers whose income is greater than 100000 and "LOW" for customers whose income is less than or equal to 100000. This value needs to be output with the final target list.

Ideally which step should be executed to get the task done?

• A. Create a User Variable HIGH and LOW with the logic: IF(Customer_Demographic_Info.Income > 100000,'HIGH','LOW').
• B. Alter the table to add a new column with the required logic.
• C. Create a Strategic Segment with the logic : IF(Customer_Demographic_Info.Income > 100000,'HIGH','LOW').
• D. Create a Persistent Derived field with the logic : IF(Customer_Demographic_Info.Income > 100000,'HIGH','LOW').

A table Customer_master contains 1000 customer_ids. A select box was created and all the customer_ids from the table were selected. However, when the select box was run, the output cell contained only a fraction of the total customers. When a test query was performed in the above mentioned select box, all 1000 customers were selected. What could be cause of this issue?

• A. The Select process was not configured properly.
• B. The table mapping of Customer_master are out-of-date.
• C. Incorrect audience level has been chosen for the Customer_master table.
• D. Global suppression.

A specialist is responsible for making sure that Unica Campaign flowcharts run successfully. If an error occurs, the specialist needs to be informed by email. Therefore, the specialist creates a batch script which interacts with the mail server and sends an email to the IT department helpdesk to be informed in case problems arise in a Campaign flowchart. Where can the specialist best relate to this script from within the Campaign flowchart? The specialist creates an outbound trigger, invokes the batch script in the trigger, and:

• A. schedules a trigger to run on a case-by-case basis.
• B. assigns a trigger in a mail list or call list process.
• C. assigns it in the Advanced settings section on the Campaign flowchart and has the trigger run on Flowchart Run Error.
• D. uses the eMessage process to send out these emails.