Test4Cram 300-410 Real Exam Question Answers Updated [Jan 14, 2022]
Easily To Pass New Cisco 300-410 Dumps with 215 Questions
NEW QUESTION 67
Refer to the exhibit.
ISP 1 and ISP 2 directly connect to the Internet. A customer is tracking both ISP links to achieve redundancy and cannot see the Cisco IOS IP SLA tracking output on the router console. Which command is missing from the IP SLA configuration?
- A. Start-time immediately
- B. Start-time 00:00
- C. Start-time now
- D. Start-time 0
Answer: C
NEW QUESTION 68 
Refer to the exhibit. R2 has two paths to reach 192.168.13.0/24. but traffic is sent only through R3. Which action allows traffic to use both paths?
- A. Configure the bandwidth 2000 command under interface FastEthernet0/0 on R2.
- B. Configure the variance 4 command under the EIGRP process on R2.
- C. Configure the delay 1 command under interface FastEthernet0/0 on R2.
- D. Configure the variance 2 command under the EIGRP process on R2
Answer: B
NEW QUESTION 69
Which statement about MPLS LDP router ID is true?
- A. If not configured, the operational physical interface is chosen as the router ID even if a loopback is configured.
- B. The loopback with the highest IP address is selected as the router ID.
- C. If MPLS LDP router ID must match the IGP router ID.
- D. The force keyword changes the router ID to the specific address causing any impact.
Answer: B
NEW QUESTION 70
While troubleshooting connectivity issues to a router, these details are noticed:
* Standard pings to all router interfaces, including loopbacks, are successful.
* Data traffic is unaffected.
* SNMP connectivity is intermittent.
* SSH is either slow or disconnects frequently.
Which command must be configured first to troubleshoot this issue?
- A. show interface | inc drop
- B. show ip route
- C. show policy-map
- D. show policy-map control-plane
Answer: D
NEW QUESTION 71
Drag and drop the MPLS VPN device types from me left onto the definitions on the right.
Answer:
Explanation:
NEW QUESTION 72
Refer to the exhibit. R1 and R2 cannot establish an EIGRP adjacency. Which action establishes EIGRP adjacency?
- A. Add the no auto-summary command to the R2 configuration so that it matches the R1 configuration.
- B. Remove the current autonomous system number on one of the routers and change to a different value.
- C. Remove the passive-interface command from the R2 configuration so that it matches the R1 configuration.
- D. Add the passive-interface command to the R1 configuration so that it matches the R2 configuration.
Answer: A
NEW QUESTION 73
Refer to the exhibit. An engineer configures a static route on a router, but when the engineer checks the route to the destination, a different next hop is chosen.
What is the reason for this?
- A. The syntax of the static route is not valid, so the route is not considered.
- B. The configured AD for the static route is higher than the AD of OSPF.
- C. The metric of the OSPF route is lower than the metric of the static route.
- D. Dynamic routing protocols always have priority over static routes.
Answer: B
Explanation:
Section: Layer 3 Technologies
NEW QUESTION 74
Refer to the exhibit.
To provide reachability to network 10.1.1.0 /24 from R5, the network administrator redistributes EIGRP into OSPF on R3 but notices that R4 is now taking a ........... path through R5 to reach 10.1.1.0/24 network. Which action fixes the issue while keeping the reachability from R5 to 10.1.1.0/24 network?
- A. Change the administrative distance of the external EIGRP to 90.
- B. Apply the outbound distribution list on R5 toward R4 in OSPF.
- C. Change the administrative distance of OSPF to 200 on R5.
Answer: A
NEW QUESTION 75
Drag and drop the MPLS VPN device types from me left onto the definitions on the right.
Answer:
Explanation:
NEW QUESTION 76
Refer to the exhibit.
During troubleshooting it was discovered that the device is not reachable using a secure web browser. What is needed to fix the problem?
- A. permit tcp port 22
- B. permit tcp port 443
- C. permit udp port 465
- D. permit tcp port 465
Answer: B
NEW QUESTION 77
Refer to the exhibit.
Which two actions should be taken to access the server? (Choose two.)
- A. Modify the access list to add a second line of permit ip any
- B. Modify distribute list seq 10 to permit the route to 192.168.2.2.
- C. Add a sequence 20 in the route map to permit access list 1.
- D. Modify the access list to deny the route to 192.168.2.2.
- E. Add a floating static route to reach to 192.168.2.2 with administrative distance higher than OSPF
Answer: D,E
NEW QUESTION 78
Refer to the exhibit.
Which two actions should be taken to access the server? (Choose two.)
- A. Modify the access list to add a second line of permit ip any
- B. Modify distribute list seq 10 to permit the route to 192.168.2.2.
- C. Add a sequence 20 in the route map to permit access list 1.
- D. Modify the access list to deny the route to 192.168.2.2.
- E. Add a floating static route to reach to 192.168.2.2 with administrative distance higher than OSPF
Answer: D,E
NEW QUESTION 79 
Refer to the exhibits. Phase-3 tunnels cannot be established between spoke-to-spoke in DMVPN.
Which two commands are missing? (Choose two.)
- A. The ip nhrp map command is missing on the hub router.
- B. The ip nhrp shortcut command is missing on the hub router.
- C. The ip nhrp redirect command is missing on the hub router.
- D. The ip nhrp redirect command is missing on the spoke routers.
- E. The ip nhrp shortcut command is missing on the spoke routers.
Answer: C,E
Explanation:
Section: VPN Technologies
Explanation/Reference:
NEW QUESTION 80
Refer to the exhibit.
An engineer configures a static route on a router, but when the engineer checks the route to the destination, a different next hop is chosen. What is the reason for this?
- A. The syntax of the static route is not valid, so the route is not considered.
- B. The configured AD for the static route is higher than the AD of OSPF.
- C. The metric of the OSPF route is lower than the metric of the static route.
- D. Dynamic routing protocols always have priority over static routes.
Answer: B
Explanation:
Explanation
The AD of static route is manually configured to 130 which is higher than the AD of OSPF router which is
110.
NEW QUESTION 81
Drag and drop the SNMP attributes in Cisco IOS devices from the left onto the correct SNMPv2c or SNMPV3 categories on the right.
Answer:
Explanation:
NEW QUESTION 82
Drag and Drop the IPv6 First-Hop Security features from the left onto the definitions on the right.
Answer:
Explanation:
NEW QUESTION 83
What are two MPLS label characteristics? (Choose two.)
- A. A maximum of two labels can be imposed on an MPLS packet.
- B. An MPLS label is a short identifier that identifies a forwarding equivalence class.
- C. Labels are imposed in packets after the Layer 3 header.
- D. LDP uses TCP for reliable delivery of information.
- E. The label edge router swaps labels on the received packets.
Answer: B,C
NEW QUESTION 84
......
You can read the Cisco Certified Specialist - Enterprise Advanced Infrastructure Implementation (300-410) Exam topics below
Candidates must know the exam topics before they start of preparation. Because it will really help them in hitting the core. Our Cisco Certified Specialist - Enterprise Advanced Infrastructure Implementation 300-410 dumps will include the following topics:
1. Layer 3 Technologies
Address families (IPv4, IPv6)
Network types, area types, and router types (i) Point-to-point, multipoint, broadcast, nonbroadcast (ii) Area type: backbone, normal, transit, stub, NSSA, totally stub (iii) Internal router, backbone router, ABR, ASBR (iv) Virtual link
Stubs
Configure and verify VRF-Lite
Troubleshoot BGP (Internal and External)
Troubleshoot administrative distance (all routing protocols)
Neighbor relationship and authentication
Troubleshoot OSPF (v2/v3)
Troubleshoot loop prevention mechanisms (filtering, tagging, split horizon, route poisoning)
Loop-free path selections (RD, FD, FC, successor, feasible successor, stuck in active)
Describe Bidirectional Forwarding Detection
Neighbor relationship and authentication
Troubleshoot manual and auto-summarization with any routing protocol
Metrics
Load balancing (equal and unequal cost)
Configure and verify policy-based routing
Troubleshoot EIGRP (classic and named mode)
Address families (IPv4, IPv6)
Path preference
Troubleshoot redistribution between any routing protocols or routing sources
Troubleshoot route map for any routing protocol (attributes, tagging, filtering)
2. VPN Technologies 20%
- Dynamic neighbor
- Configure and verify DMVPN (single hub)
- Describe MPLS Layer 3 VPN
- Describe MPLS operations (LSR, LDP, label switching, LSP)
- IPsec
- GRE/mGRE
- Spoke-to-spoke
- NHRP
3. Infrastructure Security 20%
- Describe IPv6 First Hop security features (RA guard, DHCP guard, binding table, ND inspection/snooping, source guard)
- Troubleshoot device security using IOS AAA (TACACS+, RADIUS, local database)
- IPv4 access control lists (standard, extended, time-based)
- Troubleshoot control plane policing (CoPP) (Telnet, SSH, HTTP(S), SNMP, EIGRP, OSPF, BGP)
- Unicast reverse path forwarding (uRPF)
- IPv6 traffic filter
- Troubleshoot router security features
4. Infrastructure Services 25%
- Troubleshoot network problems using Cisco DNA Center assurance (connectivity, monitoring, device health, network health)
- Troubleshoot SNMP (v2c, v3)
- Troubleshoot IPv4 and IPv6 DHCP (DHCP client, IOS DHCP server, DHCP relay, DHCP options)
- Troubleshoot NetFlow (v5, v9, flexible NetFlow)
- Console and VTY
- Troubleshoot device management
- Telnet, HTTP, HTTPS, SSH, SCP
- Troubleshoot network performance issues using IP SLA (jitter, tracking objects, delay, connectivity)
- (T)FTP
- Troubleshoot network problems using logging (local, syslog, debugs, conditional debugs, timestamps)
Cisco 300-410 Exam Certification Details:
| Recommended Training | Implementing Cisco Enterprise Advanced Routing and Services (ENARSI) |
| Duration | 90 minutes |
| Exam Code | 300-410 ENARSI |
| Exam Name | Implementing Cisco Enterprise Advanced Routing and Services |
| Passing Score | Variable (750-850 / 1000 Approx.) |
| Exam Registration | PEARSON VUE |
| Exam Price | $300 USD |
| Sample Questions | Cisco 300-410 Sample Questions |
| Number of Questions | 55-65 |
Latest 300-410 Study Guides 2022 - With Test Engine PDF: https://www.test4cram.com/300-410_real-exam-dumps.html
Get New 300-410 Practice Test Questions Answers : https://drive.google.com/open?id=1vgQKNGozQskgQTPRiE1xIcnr51HLLZ6-